Latest News

Where can I fly RC model aircraft in New Zealand...?

Please see below for a map of registered Model Fly ..
Full Article

Posted: 22/08/2017

H.O.T. Ltd, Transmitter Battery bulletin:

For Spektrum Models DX9, DX7S, DX8, DX6G2-3, DX7G2 ..
Full Article

Posted: 12/04/2017

NZIOC 2016 results

NZIOC is all over for another year. Congratulation ..
Full Article

Posted: 05/08/2016

H.O.T. LTD sponsors the 2015 Harewood Radio Controlled Off-Road Nationals

Across the weekend of 29 October - 1 November ..
Full Article

Posted: 08/10/2015

Setup Sheets from HRCCC August Meeting

New setup sheets added for: TLR0022 TLR03004 ..
Full Article

Posted: 03/08/2015
View All News

30-Amp Pro Switch-Mode BEC Brushless ESC (V2)

30-Amp Pro Switch-Mode BEC Brushless ESC (V2)

Product Code: EFLA1030B
Availability: Available to Order
Qty:     - OR -   Add to Wish List
Add to Compare

Product Description

Key Features

  • Up to 30 amps continuous current with proper air flow and 35 amps burst current (15 seconds)
  • 3.5A continuous current, 5V Switch-Mode BEC Circuit
  • Stronger BEC for support of most 3-axis stabilization systems
  • Drive up to 7 analog or 6 digital standard-size servos with the BEC
  • 3- to 4-cell Li-Po, 9- to 12-cell Ni-MH/Ni-Cd input voltage
  • Programmable motor braking
  • Safe power-arm mode prevents accidental starts
  • Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V) or 74% of battery starting voltage
  • Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
  • Programmable soft start for helis and airplanes
  • Auto motor shut down if signal is lost or there is interference
  • Programmable timing - 5 user-selectable ranges for use with a large variety of brushless motors
  • Pre-wired connectors—E-flite EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads

Overview

The E-flite® 30-Amp Pro Switch-mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

Specs

Amperage: 20-35
BEC Voltage: 3.5A continuous
Brake: Yes
Continuous Maximum Current: 25 - 50A
Height: 0.35 in (8.7mm)
Input Connector Types: EC3
Input Voltage: 3S–4S Li-Po 9- to 12-cell Ni-MH/Ni-Cd input voltage
Length: 2.0 in (51mm)
Momentary Peak Current: 35A
Output Connector Types: 16AWG with 3.5mm Female Gold Bullet Connectors
Type: Brushless
Weight: 1.1 oz (31g)
Width: 1.1 in (28mm)

 

There are no related hopups for this product.
There are no related parts for this product.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: